What is the best way to remove the plastic covering the cutout
Type: Posts; User: walleye3456
What is the best way to remove the plastic covering the cutout
I have it and think it's really good. The wind readings seem pretty accurate close windfinder. The contour maps are nice but i think you get slightly more detail with the navionics app. The other...
Those cull clips look good, what is the tag material made from
Two ionics in parallel, charger hooked to positive of one battery and negative of other. It takes some time to charge when they are low but they always are full by the next day.
The other issue is the skeg is awful close to the ground when jack plate is moved all the way down for traveling. Was hoping someone found another tire/rim combo that buys you a few inches of...
I have the stock 205/75 14 inch tires on currently
Has anyone put a different tire or tire/rim combo on the stock trailer to get some more clearance. I have the tounge as high as I am comfortable with and still have some issues with the spare tire...
It depends if going to USA or Canada side or both, the lakemaster cards stop at border, the Ontario side is not high definition as far as I know. Typically best to use navionics cards if you are...
Tried everything grounded skeg to fuse box ground, grounded Ethernet port to same ground. Also tried numerous ferrite rings at different spots with no success. I am going to give up as I am not...
I am testing again tomorrow, I did another complete reorg of all power and Ethernet wires in bow. Replaced trolling motor Ethernet cable as it had several bad looking kinks in it. Also took prop...
Using both has a lot of advantages, the 360 is constantly scanning the area in all directions. Live is pointed where you point it, unless you scan it back and forth constantly you will miss...
Do you have more than one card in the system when having issues. The helix units sometimes have issues when there are multiple cards in unit not sure if same happens on solix side. If you do have...
Is worth a try to ground the Ethernet boxes?
Fixed loose connection, rearranged all the wires around and still no luck. Same interference issues
Thanks I did check the fuse prior it was good, yesterday I think found the issue there was a buss in front for trolling motor connection, the one side was loose and an Ethernet cable near it. I am...
Ok what about steering/power cable from trolling motor should they be sperate from there as well
Tried again with battery charger unhooked, all units off except unit running live. Still get interference with trolling motor when running. Where would be next best place to check. I have checked...
I already have the choke on the wires, I am guessing then my issue is somewhere else.
Any ideas on how to fix this when batteries are in parallel and you need to cross charge
With the parallel setup the charger is attached positive of one battery and negative of another per ionic specs. I suspect this is likely the issue
I am having issues only with mega live and interference only when prop is running on tolling motor. I have mega 360, 3 helix units up front, choke installed on cranking battery but have two...
No issues after the update, if you don't use 2 Ethernet switches then you will have problems until you get 2 switches. Maybe one day that won't be the case but currently you need 2.
My trailer winch strap broke , threads came undone at hook. Does anyone know the proper replacement strap for Phoenix 921 elite boat. I got one through warranty claim but it seems a lot weaker than...
The elite has upgrade option to have rods in center
I haven't heard anything, didn't sound like I would ever get the f2