Search:

Or you can go this route for best performance:

https://youtu.be/kKsBpxT3xsQ

Cool, when I get a chance I will try it out. I want to be able to save my screenshots to a thumb drive; that would be easy and quick.

I use the usb port all the time to keep my phone charged, and...

I was not aware of this, but woud like to learn more. When you inserted your memory stick to the USB port, did it then show up under the "Storage" folder as a location? Did the size of the memory...

Consider this information:

https://www.youtube.com/watch?v=-H_E_wjfvAI&t=2s

You have to select which transducer you want to use whenever you need to switch. HIghlight the sonar page (orange border around the sonar panel) and then hit menu, then choose under "source" which...

Always verify the software version installed with any new unit, whether it be Active Target, Ghost motor, or MFD. Often software changes occur while units are in warehouses or even during shipment...

Are you sure you aren't confusing channel 1 and 2? Verify which transducer is plugged into each port on the back of your unit.

Your 3in1 "auto selects" in the settings the proper transducer.
...

I would be happy to do that but due to upcoming tournaments and using my partner's boat, I won't have mine out on the water for at least two weeks.

You just need to go into the sonar settings and turn on channel 1 and multi-source. And you should select the model transducer into the transducer settings.

You might even consider the below...

You are welcome!

Yup!

The purpose of Stableview is for use in rough water when the transducer is bouncing up and down; the purpose is to smooth out the image. I only turn it on in rough water.

So on the back of your bow LIVE displaying the Scout mode, you have an ethernet cable between your AT2 box, and your bow LIVE showing Scout mode. Do you have a second ethernet cable on the back of...

Being military myself I get not going into battle without knowing all your weapons are functioning perfectly. When you get a chance make sure your NMEA 2000 network is functioning properly. Check...

Did you install it with the app, or by microSD card? Sounds like you need to reinstall the update.

You might have something wrong in your ethernet cabling that is preventing the data from sharing with your console unit. Can you directly connect an ethernet cable between the 2 and see if it then...

https://youtu.be/pvWpSb23IMs?si=kebdRaL9MKHAJ2ES

Thank you for the information. I will download the update tomorrow, but likely won't be able to test it out for a couple of weeks due to tournaments.

I run a TM150M with the latest software and have no issues that I have seen. I do use a custom frequency and not medium chirp, so cannot speak to that.

I use a 5A fuse.

Never knew the Ghost motor had an accellerator; frankly this video makes no sense. He says you can change directions by simply pressing the accellerator and you will keep going, but he also says you...

Thanks for the update...never had a terminating resistor go out but now I will know it is a possible source of a NMEA network problem.

Agreed, SS3D if my preference also. I will get the 3in1 HD nosecone for my Ghost to complement my SS3D and have the best of both worlds where I need them.

I show how to do this in my video of installing Dual AT2 units (part 1 and 2). The part about getting into the starboard rod locker is in part 2:

Dual Active Target 2 Install and Transducer...

That is a "trick" question in that there is an offset correction that can be applied in the menu, however, this is treating a symptom and not the problem. While it may help you in one direction it...