ok Guys Im giving away 2 more bow roller kits, I have another prototype should be a sweet fit
what I need is 2 to 3 good pictures of your current old yellow roller on your 520/521
one dead...
Type: Posts; User: DREWTICK
ok Guys Im giving away 2 more bow roller kits, I have another prototype should be a sweet fit
what I need is 2 to 3 good pictures of your current old yellow roller on your 520/521
one dead...
you can but it will be the same as running 2 12v50ah
charger NOCO 10x2, Minnkota 212pcl or 220pcl
120ah or 125ah will handle that just fine
Happy to fix you up with a 125ah and it will outperform the X2 but
if you are looking for bigger
we also carry the Millertech 135ah 1500ca and 190ah 1500ca 10 year warranty
and the Monster...
Chargers can fool you with lithium, they can turn green and cut off and battery still be at 80% charged, the lower amp NOCOs are known for that, running it on the AGM setting will help
and yes...
if you use one charger YES cross the leads pos to one battery and neg to the other, works great but very slow unless you have a 15amp charger, 5 amps on a 100 or 125ah battery will sometimes result...
charge them all
use both chargers one on each battery
usually we sell the combiners based off of the starting battery, lead 13.3 or lithium 13.8, either battery will have a rest voltage below those set points, say lithium starting at 13.4 but when start...
most any deep cycle lithium 100ah up that is 50% charged or higher would start a 300hp, BUT Its not about the ability to start the outboard, its the charging ability, the battery will need to have a...
if you are charging lithium most chargers can get 130 to 145 degrees
as long as you are not pulling over 10 to 12 amps and you are starting the motor a few times a day the 125ah will be fine
we have plenty of those in stock and also other options if you are looking...
YES , AGM/HP
also dont go by the lights anymore on charge, 25% 50% 75% , just ignore those and wait for the 100% to blink green
most all Lifepo4 chargers are a one shot charge, including NOCO and Minnkota on the lithium setting, on AGM setting they might try to come back on but battery would have to be very low, unless...
if you have a lifePO4 charger it will cut off when battery is charged and it will stay off unless its unplugged and plugged back in, there is no trickling on a lithium, its constant current then off...
1100
most 3/4" round over router bits are 1/2" shank, you can find a 1/4 shank on amazon but have to be carful and cut slow ,most 1/4" shank routers are not made to handle that large of a cut
its a 3/4" Round over
I posted the 2024 catalog in the sticky https://www.bbcboards.net/showthread.php?t=1260355
https://drewcraft.com/product/gatorbaks-phx/
:nanner: Here is the new 2024 Catalog
https://drewcraft.com/wp-content/uploads/2024/04/2024-Phoenix_catalog_digital_spreads.pdf
...
Power Pole Recommends running 1 or 2 36v volt lithiums, if you do decide to use 3 12v its recommended to have a portable 10 amp lifepo4 charger to top off the center battery and occasionally the...
that charger does put out 14.6 and most AGM/Lithium chargers will put out 14.4 to 14.6 volts but you will not see that on the terminals until the battery is full and right before the charger cuts off...
there is no issues adding a 3rd lithium later, it could be 2 years later and you would still see no difference other than the cycles and end life of the others ending before the one you added
you need a 3 bank