" I know nothing" :laugh:
Type: Posts; User: Rick H
" I know nothing" :laugh:
Don's been very kind to help me several times and I support him when I can. He's a great asset to the bbc.
^^^^^ I'll second the above ^^^^^^ ^
Nice job wire to wire! :thumb up2:
:popcorn: More time for more popcorn!
Not doing anything that supports Boyd Dick! Don't care for it
180,000 miles + $4,500 = No Way!
Put a used trans in it and trade it in depending on book price
What VW
They are Radials. Thats what the "R" is.
Leases are all about the residual value. aka depreciation value at the end of the lease.
A vehicle that hold its value (Toyota) will be cheaper to lease than a (Yogo).
As close to 0.00 down...
If the lease veh. hold its value it can be a good deal. I've done a half dozen of them. Last one I bought out at the end. My total cost w/fin. was within 500.00 of sticker at the end.
Installed in the middle inner gunnel at the right spots big hole on the bottom . Then a fender dedicated front and rear.
Been running these for years. Quick on and off and fender never comes loose.
Follow the directions :wink:
Not mine! That being said I've never seen a wheel being held on with a 12mm unless its a 300 buck HF pos. :wink:
You all need to be patient. Mark does great work. Its not a fast process to get it right and he will its an art not mass production. Early spring is the busy time for this. If your chomping at the...
Thats true too but the combination of all of the above amplifies the problem.
I ordered this last fall. Mainly to keep side of road tire changes as short as they could be.
I've tested it rotating tires and it doesn't even breath hard doing it. Has several load setting to...
I've yet to ride in a metal boat that rode and handled better than a glass boat.
It looks good and better then most metal boats but that price point won't help it sell.
It BETTER fish really,...
They can be stripped pretty easy by over tightening the fastener. I use a short wrench to help that not happen.
Repair hole in wood just like and other stripped hole. I use a good wood glue and...
If I could buy another 250 XB then I'd do that but I can't so.
Suzuki Yamaha
It never fished great but did fish better before they dropped the level to put the marina in. Never really recovered after that.
If they would manage it for bass it would do better but I can't...
These work well
https://www.taylormadeproducts.com/products/fenders-and-buoys/boat-fenders/square-low-freeboard-fenders/
With These. But I installed them with the insert hole on the bottom.
...
COOL!!!
Follow prep directions. Works above and below the water line even at 70 +.
https://www.southcentralfloridalife.com/detail.html?sub_id=6ffcd74111