545379
Put the new cover on my P2 over the original clam hole...drilled a second hole nextthe original hole
Type: Posts; User: 18P2
545379
Put the new cover on my P2 over the original clam hole...drilled a second hole nextthe original hole
544587
Put it on the cup holder!
I never use my cup holder either so that may be the spot
Where are you putting the gps/compass puck at the bow? There is not a flat surface on the fiberglass areas at the bow.
I had iguana numbers on my last boat for 9 years and they were just about good as new
It won't. The new cover is 5" wide
Snap shot this from John crews' video on his caracal.
540190[/ATTAC[ATTACH=CONFIG]540191H]
Does anyone have one of these installed on their boat at the bow? Looking for some photos
539768
Gen 2
Looking for helix 7 gimbal bracket
I have the same problem with my solix. But I also don't have a heading sensor
Two of these side by side will fit almost perfectly in the front middle compartment. They hold the Plano boxes perfectly.519913
https://www.boatfax.com/
https://www.boat-alert.com/
https://boathistoryreport.com/
Used to be a guy who had a business called duramatz. He would make a padded mat that laid on the deck for about $200. Not sure if he's still in business anymore
Next question. These power wires appear factory at the bow and come from the factory power strip at the transom517768517768. If I connect the 360 to power at these wires do I need to put a 1amp in...
Thanks!
I'm running power for the 360 to a power strip at the console. 360 manual says to connect the drain wire to a ground terminal or boat chassis. Can I connect this drain/shield wire to the negative...
Can you post a side view of the mount?
Looking for some pics on how to route wires at the bow. As in tranducer/360 from trolling motor to the graph unit
Greg took care of me. Big thanks to him!
Is anyone in the Dupo IL area that could look at a used boat for me at a dealer? PM me if you can!
80's mariner 25hp motor. S/N 0G189303. Engine starts and idles great. But when I put it in forward gear and give it throttle it bogs down and stalls out. Gas lines are new and has fresh fuel.
...
How can I cap this hole?488947488947
Looking get myself set up with a drill auger. I just don't know what drill to get. Looking for some suggestions on model numbers on drills that work well for augers.