Thanks Lightning 6
Type: Posts; User: aby n
Thanks Lightning 6
Hello all, I am about to upgrade my fuse panel & wiring on a 82' ranger 350.
I believe it's the factory fuse block & most likely has random fuses inserted to get by.
Is there a good reference...
BRNut, who offers / makes those corner switches? I wish i knew before i bought what i did. Those are awesome.
Thanks for the info guys & the links from brownG
Hello All,
I have an 1982 ranger 350v & the trolling motor is an old motorguide & it's noisy & getting difficult to control = lots of effort.
I measured the shaft length from the top of the...
Hello All,
I have an 82 ranger 350v & the trolling motor is an old motorguide & it's noisy & getting difficult to control = lots of effort.
I measured the shaft length from the top of the motor...
Thanks for the insight.
I have seen bolt-on fins on some boats. Is that really necessary for a 82 ranger 350v w/150hp merc?
Hello all, i noticed damage to my lower unit horizontal plate / fin on my 1982 Mercury BM 150hp sn# 6101202
I am open to hear all suggestions for repairing this housing, that doesnt require the...
Thank you massbays!
Thanks guys!
Any suggestions on where to buy one under it's name?
I just searched zinc anode mercury bm & only came back with the circular piece with a fin on it, that lives under the lower...
I noticed this broken brace on my 1982 Mercury BM 150hp sn# 6101202
What is the name of the broken brace in the pic attached
What are some reasons this brace would break the way it did?
...
I didnt realize that there was a difference between the 2 autozone duralast 31-950's, 1 being MF & a flooded wet cell.
Thanks guys, i will verify.
Thanks leoreno, i installed a cdi stator.
I spoke with cdi earlier today & he said my duralast 31-950 was the issue. He said the maintenance free batteries are the issue.
He also said the deka...
1982 Mercury BM 150hp sn# 6101202
So i have a 1982 BM, i recently put battery voltage on my lowrance screen & have noticed at idle / low rpm the system is putting out ~13.7v via lowrance. But at...
^ CDI Electronics 174-5456 9 amp
Engine now turns off as expected!
i discovered fried yellow stator wires during the inspection, so i swapped out the stator, rectifier & both switch boxes.
Side note, i didnt capture running...
...
wow, tilting the motor all the way back was HUGE! started up both days on the 2nd try!!
Hello, I have a Daiwa Tatula 150 right hand 5.5 ratio reel for sale, spooled up with inviz-X 17lb line.
I thought i was going to be throwing wake baits or s-wavers, ehh thats not for me.
I used...
No, with the old parts in it. I couldnt replicate the issue, so i swapped all the bits out.
oddly enough with the fried yellow wires, with the motor running, i was getting 13.5x V at the battery....
Thanks!
Update:
Couldnt replicate the "engine running after key off" in the garage, even after a long warm up.
I went ahead & swapped out stator; due to charred yellow wires, rectifier & switch boxes....
Hello, I have a hdi skimmer with a 25' cable that i want to use on my trolling motor.
Is it possible to shorten the cable without messing up the signal?
Can i cut out the section & solder the...
Thanks guys!
Is there anything i should be aware of using ch1, besides verifying it's identifying my sensor correctly?