I just installed a "new to me" ultrex. Seem to have the wiring done correctly. I haven't had it in the water yet but on the trailer I can get it to run when I push the foot button. All the indicator...
Type: Posts; User: onpoint
I just installed a "new to me" ultrex. Seem to have the wiring done correctly. I haven't had it in the water yet but on the trailer I can get it to run when I push the foot button. All the indicator...
Can you replace the bow eye when the boat is on the trailer up tight to the roller?
I have about 15 Duckett rods that I was going to sell but now I think I'm going to cut them up into pieces and mail them to Boyd's house.
What's a good brand of trailer tire? I have a single axle Ranger Trail.
I think I'm going to see if there is enough slack in the oil lines to move the tank to the center, then I can mount the additional battery beside the cranking battery and I'll make jumper wires to...
On the driver's side there is the cranking battery and the oil tank. There is a removable piece over the bilge area in the center, then I have 2 27 series trolling motor batteries. So I would be...
I have a 93 361v that I'd like to get a trolling motor with spot lock installed. I can find used ones but most are 36v. Is it possible to fit a third battery in the rear compartment in some way?
Schwarzel Marine in Hockingport. Blaine has been doing it for YEARS and will do a great job. IF it can be fixed, he can do it.
Sent you a PM
The store at Chippewa Bay has gas
I have a fast strike 150 that needs rebuilt or a new powerhead. If I switch to a Yamaha will I have to change my OMC controls and hydraulic steering hookups?
I have a 93 361v with a 94 fast strike 150 that unfortunately needs rebuilt or a new powerhead. I found a used Yamaha. My question is I have OMC controls and hydraulic steering, what will I need to...
I talked to one dealer that was hesitant to say they would even work on it because of the age but if they did they would put a new powerhead on it for about 6k. Another dealer talked like it was no...
I got it to start but it runs rough. Did a compression test and 4 cylinders are 100+, 1 is 70 and 1 is zero. What can be done?
I just looked at the tank and it looked like it had 3/4 of a tank, it's my fault for not taking the cap off and actually looking. But no, never got a warning horn for low oil. It will turn over now...
I have a 94 fast strike 150. I was cruising at 40 mph then I noticed I was slowing down, when I gave it more throttle it didn't respond so I stopped and the motor died. When I checked the oil tank...
I'm thinking about getting in as a coangler if I can for the July 8 derby. Any boaters needing to link you can text me at 740
-504-0033. Chuck
I have a TH Marine hot foot with cable that I've had for years. Got it used and never installed it. I can text you pictures if you are interested. Message me with your phone number. Shipped TYD $120.
So the bow panel trim buttons work, the trim buttons on the motor work, but on the gearshift/throttle lever it will only trim the motor down, and not up. Does that lever come apart and I replace the...
OK, thank you!
What is "Crowley"?
Took it out for test run and after it wouldn't start I took the cover off and noticed when I squeeze the primer bulb fuel would squirter out of the top of the vapor separator tank. Any thoughts would...
Varies from year to year but a friend/guide down there told me that after the spawn when the fish move out and start feeding again (late april/early may), that was his favorite time. You can sit in...
I have a 93 361 which I love. Has a 150 fast strike which has been strong and awesome. Love the way it fishes, runs, and handles. Just wish it was bigger.
I have some of all those types. What's the going rate that you're paying?