:thumb up2:
Type: Posts; User: JOE54
:thumb up2:
fault scan will provide precise information for you
will need fual codes scanned for precise info on causes , please use the 3.0l forum for your engine 2 more down the list , good luck JOE
^^^^^^^ +1 exactly please use the 3.0l forum for more info on those engines
spark on all 6 ?? you got any pics of those plugs , you may have a detonation problem going on there , also may need to isolate non working cyls
GEN 2 gearcase in a HP application i would use solid hub on the 1.25 shaft although i have not seen the hard shift with the SSR hub and have ran one on one of my personal boats GEN 1 case
oil pump prime is recommended with diagnostic equipment , lap the reed cages as described on this forum ,do a search here form good info, reeds that are to tight or to loose can cause some running...
recommend having faults read /scan to determine alarm cause , possible low voltage
inspect top edge closely most seem to crack there
:thumb up2:
^^^^ +1
:thumb up2:
fuel ;pumps will be a buzzing sound port side of engine
^^^^+1
fuel psi at idle please ????
^^^^^+1 eliminate boat as source of problem use a separate fuel supply and new OEM fuel line no afterjunk
inspect reed /are they the original carbon fiber????
try connecting orange wires together and activate trim
new check valve doesn't mean good check valve / have seen some new bad ones
most i see are 170*
89984T5 / has no top housing
agree
very low batt voltages
shouldn't be a problem replacing would check for broken wire first
does it have a limit switch installed in trim system under cowling , possible problem