Can i put an aftermarket recessed foot control pan for my trolling motor on this boat? Are there spars in the way?
1997 Stratos 282DC
150 Intruder
New Market Alabama
Printable View
Can i put an aftermarket recessed foot control pan for my trolling motor on this boat? Are there spars in the way?
1997 Stratos 282DC
150 Intruder
New Market Alabama
i did one in my 1999 273, nothing under there but TONS of foam.. http://www.bassboatcentral.com/smileys/thumbsup2.gif
I'm in the process of getting the SawsAll ready. I just took these picts today. Slid the camera down the bow panel.
Straigth down the middle. My boat has a livewell in the front jsut behind the pole.
then to the right you can seen my rod tubes. then to the left (drivers side) Looks pretty clear on mine.
http://media11.dropshots.com/photos/...313/191726.jpg
http://media9.dropshots.com/photos/2...313/191730.jpg
http://media11.dropshots.com/photos/...313/191744.jpg
Modified by StratosDadRI at 9:50 AM 3/14/2011
I installed one in my old 278, no problems at all. http://www.bassboatcentral.com/smileys/USA1.gif
I installed one in my 1997 VR282. You will have to notch the front of the storage compartment wall. No big deal, it is a relatively thin plastic.
Thanks for the info folks. When i up grade m y trolling motor i will add the pan.
Fish on!
Here is a link to my install guide it is on a 94 270.
http://trollwell.com/shop/page...param=