Lift Assist for Minn Kota MAXXUM Trolling Motor

I posted some information on this previously but have recently created a PDF giving parts list and complete installation instructions. I have not figured out how to post an attachment to the forum, but if you PM your email address, I will be happy to send you the PDF. Total installed cost of this project is under $30 if you have a 5/16-18 tap and correct tap drill size. If not you can buy the tap and drill in kit form at Lowes for about $8.00.

http://www.bbcboards.net/attachment....d=302976&stc=1

Bill: Sent you a Pm with my e-mail. Thanks in advance.

PM sent.
Email available in my profile.
Thanks!

PM sent. Thank you.

Got the info. Thanks again Bill.:thumb up2:

Quote:

---

Originally Posted by CastingCall

PM sent.
Email available in my profile.
Thanks!

---

I could not figure out how to attach a file to the forum email account and did not see another account. Sorry

Got it! Thank you.

Quote:

---

Originally Posted by Bill Reynolds

I could not figure out how to attach a file to the forum email account and did not see another account. Sorry

---

Got the PDF, Thanks Bill!

Couple questions:
Are the threads on the ball studs 1/2" long? Can they be longer?
You state drill the tap holes 3/4" deep... is the cast area solid that entire 3/4", or are you tapping a thinner chunk of casting in that area?

With 4 washers on the stud, to extend the stud away from the mount, is there concern there isn't much thread going into the casting?

Quote:

---

Originally Posted by CastingCall

Got the PDF, Thanks Bill!

Couple questions:
Are the threads on the ball studs 1/2" long? Can they be longer?
You state drill the tap holes 3/4" deep... is the cast area solid that entire 3/4", or are you tapping a thinner chunk of casting in that area?

With 4 washers on the stud, to extend the stud away from the mount, is there concern there isn't much thread going into the casting?

---

the Thread length is 1/2 inch and could be longer if you can find them.
The casting is much deeper than the 3/4 I used that dimension to give some clearance for the tapered threads on the tap.
Your point about the amount of thread engagement with the washers is a good one. I have not had a problem but would not use more washers than absolutely necessary to get clearance for the struts.

Sent you PM

PM sent

Thank You Sir!

Would like to receive the pdf you mentioned. Please send to tablerocktackle@live.com

Would also like a copy of pdf file. Send to cantrelln@yahoo.com. Thanks in advance.

Pm sent. Thank you sir

Thanks for the instructions. Even I can follow them:)

Quote:

---

Originally Posted by mlh1955

Thanks for the instructions. Even I can follow them:)

---

You are welcome. Hope this works well for you.

Bill,

Can I get a copy of the instructions too? tward690@comcast.net

Thanks

PM sent. Thanks!

Would like to receive the pdf you mentioned. please send to goffmcmahon@gmail.com. thanks.