Have any of you guys added a recessed pedal tray to your boats? I have a 2005 ZX 225 that I am thinking about adding one to.
Printable View
Have any of you guys added a recessed pedal tray to your boats? I have a 2005 ZX 225 that I am thinking about adding one to.
I've puy 2 in. 1 in my zx185 and 1 in my buddys 2005 zx 225. Piece of cake. Taped down the template, measured twice. Drilled a hole thru the deck in each of the 4 corners of the template and finished the cut with a sawzall. Dropped in recessed tray and screwed it down.
was there any concerns for a cross beam under the deck? did he have a minn 101?
No cross member in either one I did. He has a MG Tour 82. I centered both on the front deck about 1 1/2 to 2 inches back from the bow panel to the front lip of the recessed tray.
I put one in a zx250 (04) and someone on hear recommended putting bracing in on each side of the hole. so thats what I did and I have no problems after 3 seasons http://www.bassboatcentral.com/smileys/thumbsup2.gif Mine was a 101mk also
I posted this pic a few days ago for someone on here. I reacentley bought 04 zx 250 that had recessed tm pedal installed . It was spongey so took it out and made this strut from allum. angle its really solid now . check out how thin deck is had reinforcement that was cut when installed.
[img]http://i1106.photobucket.com/albums/...1-22134934.jpg[/img]
Looks good turbo http://www.bassboatcentral.com/smileys/thumbsup2.gif
You should spread some epoxy resin on the edges of the cut out to prevent water soaking into the foam. http://www.bassboatcentral.com/smileys/thumbsup2.gif
I will do that this winter . Thanks for advice
Looks like a good support. I have customers and even myself when I installed the first Troll Well worry about deck integrity. I had no problems and have never had an issue reported about a deck flexing after install.
Since you plan on epoxying the exposed foam you also may want to consider a wider base to distribute the load on the bottom of your support on hull. If deck is thin enough to flex I would also worry about the thickness of that hull and the narrow pressure over time from your support base pressing down.
Put one in my 2005 TZX 200 last week, easy peezy!
[img][/img]http://img.photobucket.com/albums/v2...me/photo16.jpg
I do have a question, do most of you screw the foot control into the recessed trasy or just leave it loose in there?
I screw it down .