Carb gaskets on my 60 degree 150 intruder

What can I put on my 6 gaskets and intake gaskets to hold them in place. The gaskets keep popping off. Thanks John

Are you talking about the ones that go on the carbs between them and the airbox?

No I am not. These are rubber gaskets individually that go on the back of the carbs. There is one big one for each side behind the carbs connecting behind that thick plate with adjustment screws going in front of the intake manifold.

what colour is the gasket?

Try a little bit of triple guard grease on the block side not a lot just enough to hold them. They are the brown gaskets correct?

There are six gaskets on the back of the carbs. They look black and are inserted in the back of the carbs. They will not stay in place. There are to tan ones made out of the same material that go on the metal plate that the carbs connect to.

Do as championman said ,use grease .have a nice day

you can use a Hi tack gasket sealer but just dob it with a Q tip at the corners, you sure don't want to mess this up. If you pop the motor you will know exactly which one is gone due to a gasket pinch/flattening out. http://www.bassboatcentral.com/smileys/wink.gif

Thanks . I will try triple guard grease or omc gasket sealer.