Re: Tilt not working (CIDGCN002)
Follow the wiring from the t&t motor (between the transom clamp brackets) to the engine wiring harness connector underneath the motor cover. The wires will be green and blue. Use a couple of nails or small screws to contact the terminals in the connector and provide 12 V from a battery. If you hook the blue wire to +12V and the green to ground the trim and tilt should go up. Reverse the wires and the t&t should go down.
If it works when you jump it like I described, the t&t motor is good and the problem is with the relays, switch or wiring.
If it doesn't work like I described, you need a new trim motor.