Trim and Tilt not working 200 ficht

It worked fine all day than when I went to put the transom saver on, Nothing ! Then to make matters worse the screw driver came out of the slot on the manual release and my feet slipped and down she went all the way to the ground. Could not raise her by hand had to use the jack from the truck.

My question is where will I find the fuses for the trim and tilt? My ficht is on a Ranger 619 I have checked the fuse for the front panel switch. Is there an inline under the cowl? Or could there be an other location for some fuses?

Any help would be Great.

At least I had a good day of Fishing!

Ranger Tim

Right side of the motor (from behind).....black cover two slotted screws...Power Distribution Panel (PDP) remove the cover and check the fuse between the relays, if its not blown you may need a PDP.

You did not post if the motor would still crank over.

Rusty

Yes, the motor will crank over and it was running fine all gauges and other acc. were good too.