my motor trims up fine, but when it goes down its real choppy and bounces alot. Is it just air? How can I get it out?
Printable View
my motor trims up fine, but when it goes down its real choppy and bounces alot. Is it just air? How can I get it out?
Chad,
you can do a search on the bleed off procedure here, but short and sweet, trim motor all the way up, support with trailering bracket. remove the cover plug off the reservoir and check fluid level fill if needed. Secure cap and trim up to release bracket. Trim all the way down and put a block of wood on the floor under skeg. Loosen the manual release screw on side of mounting bracket about 1/2 way down (slotted screw) about 2 or 3 turns. Trim motor up for 30 seconds (motor should not go up) then down for 30 seconds. Cycle this 5 times and tighten the manual release screw this should get you going.