Printable View
The lower shock mount pin on my Yammie 150 has lost a bolt/washer/bush and has worked itself loose - I was able to hammer it back in from one side but I can't get it to completely realign on the starboard side so I can re-bolt it from the other side...any suggestions? When I trim/tilt the motor, I can get close to realignment but not enough to get the shock mount pin all the way through.
http://i47.tinypic.com/afd378.jpg
Modified by johnjay51 at 4:56 PM 11/26/2009
Have you tried trimming the motor all the way up and using the engine tilt support bracket to release the pressure from the tilt/trim unit?
there is a up-dated pin, bolt ,washer set-up as this is a fairly common issue. If you go back with the original bolt washer set-up make sure you put "red" loctite on the bolts and tighten http://xs-s.com/zf/images/smile/emthup.gif " should not be that hard to re-align just use tour trim and trim up are down? http://xs-s.com/zf/images/smile/emthup.gif