Is there a service procedure for the tilt/trim?? I know notta about this.. Do u check a fluid? If so where is it located? Its a pro v 150. I just wanna keep it properly maintained.
Modified by fiddlinfool77 at 12:47 PM 5/19/2008
Printable View
Is there a service procedure for the tilt/trim?? I know notta about this.. Do u check a fluid? If so where is it located? Its a pro v 150. I just wanna keep it properly maintained.
Modified by fiddlinfool77 at 12:47 PM 5/19/2008
Tilt the engine all of the way up & lock it in place with the tilt lock (It flips down manually). From the back of the engine, look to the right of the tilt ram for the fluid reservoir, and on the fluid reservoir you'll see a cap. Unscrew it slowly (you may hear the sound of air escaping, which is normal because it's bleeding out the air). Once the cap is off, if fluid runs out, it's full. If no fluid runs out, you can add some.
If I had a picture, I'd post it.
It's a two minute job. http://xs-s.com/zf/images/smile/emthup.gif
I guess im not looking in the right spot.. Anyone have a pic where the rezzy for fluid of tilt/trim is on pro v 150?
Try going to Boats.net Type in information requested,you'll get a diagram of each engine component,just zoom in.
I found a plug that has a allen head on it.. I started to unscrew it and a clearish fluid started to come out, so i just tightened it back.. Is this the rezzy and fill place for the fluid? If so, I assume its ok since fluid started to come out of the hole as i loosened it?