Procraft Trailer

Got a question about a 1991 Procraft trailer. Does anyone know what is the size of the bearing seal. I decieded to service the bearings on the trailer after I bought it. Ran into trouble when the I discovered the bearings are 1 1/16 front and 1 3/8 rear. The problem I ran into was the seal did not fit the stock hub, outside seal diameter was too big and wouldn't go in. I got new standard hubs and thought that was the fix; however, that was not the case. A standard 1 3/8 seal will not seal tight against the axel spindle and all the grease goes out past the seal. Anyone have any ideas or I do I need to measure the the hub and the axel and get a seal based on the measurements. Thanks

The seal description on the 1991 Procraft should be 233-168-SP2 or NOK # AD2527E if you have UFP hubs.

DABS, thanks again for the response and the help on the phone. The hubs did end up being UFP. Oddly enough the boat was originally equipped with bearing buddies, sticker on trailer frame, as opposed to the UFP trailer buddies. Repacked bearings last night and ran it today. No leaks. Thanks again for the help.

Anytime sir.