More Problems!!!

well... got the bathroom tile up and everything looks great BUT..... the tub spout leaks out to the back. I went out and bought a new one but same thing. The problem is the pipe. Its kinda chewed up underneath where the set screw was seated numerous times by the previous owner. I can pull the spout out till the o-ring just slips onto the pipe and no leak but its too far from the wall if I do that. The O-ring isnt making a good seal. Is there anyway to build that copper back up in that area? I've tried smoothing it out with some emory cloth but that didnt really help. I can get to the joint (I think) and solder in a new piece of pipe but am kind of worried about catching the stud on fire thats behind it. The hole isnt big enough where I could get something in behind the joint to dissipate the heat nor can I heat the joint from the rear. Ideas? Thx!!!

Solder a threaded copper 3/4" fitting on the end and buy a screw on spout.
Just measure the pipe length in case you need to cut or add to the length for the new spout.

Thx for the idea bit I think I finally got it! I cleaned the pipe really well and then put some JB Weld on it and put some cellophane tape on it overnight to smooth it. I sanded it this morning and just left the gouges filled in. Seems to be working. Time will tell! If it starts leaking again I'm going to take your suggestion. Thx again!!!

when installing a new diverter, take your cutters and take off 1/4-1/2" if it's chewed up like described and it will give ya some fresh copper to play with. if it's in decent enough shape, just clean her up a tad. whether just putting your old diverter back on or new one, make sure ya lay some heat grease on the pipe to help create a seal and will also help keep that o'ring from drying out anytime soon....jmo

Well... I spoke too soon. It lasted for awhile but started leaking again. I went ahead and wet a small towel and put it behind the joint and just put a new piece of pipe in. Didn't even start a fire! http://www.bassboatcentral.com/smileys/Laugh.gif Anyhow... all is good now. Thx for the suggestions!!