a dock and has a small gouge ( 1 inch by 1 inch) in it. The hull is black so my question is what is the best way to repair it?
Printable View
a dock and has a small gouge ( 1 inch by 1 inch) in it. The hull is black so my question is what is the best way to repair it?
I would suggest expoxy thickened with a fairing compound then touch up with some black paint.
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by coachallen »</td></tr><tr><td class="quote">a dock and has a small gouge ( 1 inch by 1 inch) in it. The hull is black so my question is what is the best way to repair it?</td></tr></table>
Depends on how much you want to spend, and how close of a match you want for the gelcoat.
How deep is the gouge ? Just in the gelcoat or does it go down into the glass mat ?
it is just in the gel coat. I want to match it as much as possible
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by coachallen »</td></tr><tr><td class="quote"> it is just in the gel coat. I want to match it as much as possible</td></tr></table>
You'll need to get some black gel coat, either from the boat manufacturer, or one of the gel repair kits from Evercoat.
http://www.wholesalemarine.com....html
If using the repair kit, follow the directions for mixing the catalyst into the gelcoat. MEKP is the catalyst, treat it like acid, so be careful when handling it.
If using gel from the Manufacturer you'll need to get a small tube of MEKP,
( Methyl ethyl ketone peroxide) available at most auto stores.
Clean the chip area real well, lightly sand the edges to remove any loose particles, using a Dremel tool, bevel the edges sloping into the repair area. Make sure there are no ledges.
Tape off the area around the repair.
Stay close to the repair. Make sure there are no tape ends in the sanding area. The purpose of the tape is to avoid a mess and protect the area around the repair from the sand paper.
Mix about 1/4 to 1/2 inch of Gelcoat in a paper cup with 5-7 drops of MEKP.
Stir completely, with a wood tongue depressor, the MEKP will start a chemical reaction in the gelcoat. You'll start to feel the cup heat up a little, this is normal.
If on the top cap it is pretty easy, follow directions on mixing the catalyst in the gel...if on the sides/bottom you'll probably have to build it up in layers. You can thicken the gel by adding pure talc powder to make it a paste type to get on hard to reach areas.
Build the gel a little over as it will shrink some, if you see any air bubbles pop them gently with a pin..........should be cure in 4 hours, but waiting overnight to sand is best.
You will need a piece of waxed paper over the repair to seal it off and help the curing as gelcoat will not cure in air.
Just lay the wax paper directly over the wet gelcoat to keep air off it.
If the surface is still sticky on top but the gelcoat is hard underneath, wipe off the tackiness with acetone so your wet sand paper does not gum up.
Acetone is also used for the cleanup ( fingernail polish remover )
Once it is completely cured you can start finishing it.
Use a small sanding block and 600-800 WET sandpaper to get a smooth finish, keeping the paper wet, if sanding lines are still seen up the sandpaper to 1000-1200
If you see a shadow below the sand area you are about to go through the Gelcoat and into the glass and resin. stop sanding.
Once you get the chip sanded smooth you can compound and wax.
thank you sir