help with a lifting eye

Printable View

11-15-2009, 06:21 PM
JavRenegade20

help with a lifting eye

I got a lifting eye for a '08 etec 225..

I tried to mount it to the flywheel of an '03 225 ficht and the three holes lined up but the threads on the bolt were different.. Does anyone know if I can just get the bolts and use the lifting I have???

Seems like the bolts for the '03 are a tad smaller than the ones for the '08 etec...

thanks
11-15-2009, 06:42 PM
hulapopr

Re: help with a lifting eye (JavRenegade20)

should be able to go to any auto or hardware store and get what you need,get case hardned.find one to match the holes you need to fit and take it with you.
11-16-2009, 03:58 AM
SEAHORSE

Re: help with a lifting eye (JavRenegade20)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JavRenegade20 »</TD></TR><TR><TD CLASS="quote">I got a lifting eye for a '08 etec 225..

I tried to mount it to the flywheel of an '03 225 ficht and the three holes lined up but the threads on the bolt were different.. Does anyone know if I can just get the bolts and use the lifting I have???

Seems like the bolts for the '03 are a tad smaller than the ones for the '08 etec...

thanks</TD></TR></TABLE>

They should both have the same thread, 5/16X24NF unless someone got tapping away in the holes
11-16-2009, 05:21 AM
JavRenegade20

Re: help with a lifting eye (SEAHORSE)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by SEAHORSE »</TD></TR><TR><TD CLASS="quote">

They should both have the same thread, 5/16X24NF unless someone got tapping away in the holes</TD></TR></TABLE>

Thanks.. is the flywheel cast iron, steel? Could there be a little rust in the threads? on my '08 i can hand thread them, on the '03 i couldnt get them to start.. I didnt get up an look at the threads to see what was going on .. I will get up and look at them tonight...

thanks
11-16-2009, 05:26 AM
ChampioNman

Re: help with a lifting eye (JavRenegade20)

I believe the recess on the '03 is a little deeper than the e-tec. The '03 is the old style V-6 looper flywheel and the bolts on the e-tec lift ring are too short to reach the threads on the '03. If you get the bolts like Seahorse describes and get a harmonic balancer, eyebolt and some big washers you can make your own. http://www.bassboatcentral.com/smileys/thumbsup2.gif
11-16-2009, 02:06 PM
JavRenegade20

Re: help with a lifting eye (ChampioNman)

I ran a 5/16 chaser bolt thru and its fine now.. there must have been some smut in the threads..... thx