Just installed the water Pressure sensor on my 115 and it does not display on the App. I erased the app off of my phone and re installed it. Still no pressure reading. I’m stumped at this point.
Printable View
Just installed the water Pressure sensor on my 115 and it does not display on the App. I erased the app off of my phone and re installed it. Still no pressure reading. I’m stumped at this point.
Never mind!!!!’
jeez! With the engine running touch the RPM screen and select water pressure! Amazing:doh:
Can you describe how the sensor is installed? I'm interested in one for my 2022 Merc 115 Pro XS
Couldn’t be easier. If you have the analog gauge you will just remove the plug with the tube connected to it. Install new sender and plug it in. Plug is already in place. If you don’t have analog plug there will just a plug that you will remove and then install the new sensor. Super easy and straight forward. Good luckQuote:
Originally Posted by Dmy-rt188p
Thanks ifishinxs. Did the sensor sync with your Vessel View without any further update or modification?
No other modifications required- the PCM is already monitoring the circuit for a sensor (it's just not there).
Don
I would like to keep my analog gauge is there a kit to make that happen.
Yes, it sync’s right up.Quote:
Originally Posted by Dmy-rt188p
What is the part # for the pressure kit?Quote:
Originally Posted by ifishinxs
These need to be done with ONE engine (including it's serial number) per thread. This is very important as there's an earlier 115 that's a totally different engine/scenario.Quote:
Originally Posted by Mike Carroll
2010 Pro XS 150
SN 1B882930
This motor has two pressure sensors connected to wiring harness - only one of which is connected to the grey pressure tubing from block. Can one of these be replaced with the “digital” sensor to enable WP via Veasel View Mobil?
thanks!