Need Help! PowerPole Reservoir Access/Placement - ZX250 2017
Hello All and I'm hoping someone can share some insight here as I can't be the first guy to face this.
I'm getting a "new to me" ZX250 and, as they come, it has 1 8ft PowerPole and I want to add a second. That said, the existing reservoir that came from the factory on the starboard side is tucked all the way to the side of the boat and I cannot figure out how to get the other one in on the port side to match its placement??? Same goes with servicing or checking fluid on the existing one. Mounting the reservoir with minimal room coming in from the top seems really tricky if not impossible, to drill pilot holes, mount bracket, connect fittings and so on. Can I take the deck corners off? Can I access from the rear compartments? How have you guys done it?
Its an awesome boat but they don't give you much to room to work with in the bilge. I'm coming over from Nitro where there's a lot of room back there.
Also - how did you run the other two hydraulic lines? Make a bigger hole and buy a bigger vent cover?
Anyone's advise is greatly appreciated.
Thanks in advance!