Thread: Jack Plate Size

Results 1 to 4 of 4
  1. 07-31-2019, 08:36 AM #1
    FishNChip
    FishNChip is offline
    Member
    Join Date
    Jul 2019
    Location
    Louisiana
    Posts
    22

    Jack Plate Size

    I want to install a digital indicator for my Atlas hydraulic jack plate and need to figure out what size I have. Entire setback from the transom to motor mount is 9" but this is comprised of the jack plate and a forward bracket with a hole shot plate on the bottom. Pic is attached. Do I have an 8" or a 4"?IMG_0622.JPG
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. pmgoffjr
    pmgoffjr is offline
    Pat Goff
    Join Date
    Jun 2004
    Location
    Seadrift TX
    Posts
    10,942
    #2 07-31-2019, 09:00 AM
    It shouldn't make any difference.
    But you have a 4" if it does.
    Pat Goff

    Two degrees from center
    of nowhere.
    Smithwick TX.

    [SIGPIC][<a href=http://www.bbcboards.net/image.php?type=sigpic&userid=583&dateline=1498828542/SIGPIC] target=_blank>http://www.bbcboards.net/image.php?t...828542/SIGPIC]</a>
    Reply With Quote Reply With Quote
  3. FishNChip
    FishNChip is offline
    Member
    Join Date
    Jul 2019
    Location
    Louisiana
    Posts
    22
    #3 07-31-2019, 09:04 AM
    The vendor offers two sizes, one for 4-6" jps and one for 8-12" jps. So it seems to make a difference.
    Reply With Quote Reply With Quote
  4. pmgoffjr
    pmgoffjr is offline
    Pat Goff
    Join Date
    Jun 2004
    Location
    Seadrift TX
    Posts
    10,942
    #4 07-31-2019, 11:40 AM
    Gotcha.
    Never rigged an atlas just a few hundred bobs.
    Pat Goff

    Two degrees from center
    of nowhere.
    Smithwick TX.

    [SIGPIC][<a href=http://www.bbcboards.net/image.php?type=sigpic&userid=583&dateline=1498828542/SIGPIC] target=_blank>http://www.bbcboards.net/image.php?t...828542/SIGPIC]</a>
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »