94 zx200 with 94 200 venom Johnson,,,,cmc 6” hyd jackplate 1 power pole,,,,was running a mark crouton worked 25p renegade and getting maybe high 50’s ar wot 5800 rpm great hole shot,,,I went to lithium’s and took about 200# out of the back due to that, now the prop is going over 6000 rpm (easily) ,,,, suggestions anyone? Thanks
Joe, did you ever try the 26 Raker II that you were looking for thrust washer for?
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
It’s a raker 1 and yes I did couldn’t get on plane , but I haven’t tried taking out plugs yet
Last edited by blkfalc4; 07-21-2019 at 11:09 AM.
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
Is there any rule of thumb with removing the vent plugs?or trial and error
A raker one usually doesn't have PVS vent holes with plugs just 3/8" vent holes. If yours has PVS plugs in it take one out and try it if that doesn't do it pull another one.
Ok thanks, mark put holes in mine for plugs, so I will pull one at a time, thanks
If it has PVS holes drilled you can change the size plugs in it until you get between 3500-4000 rpms at break over.
Thank you I will do that
Reply With Quote