I've disassembled the reeds on my 200 Opti (ser# 0G886121) to replace. While doing this, I discovered I have two different size reed blocks. There are three sets of blocks that are about an 1/8" or so longer than the other three, but appear to have the same degree of radius. I did notice the shorter ones (I believe the original???) had more wear on the bottom of them like the reeds underneath them had been hitting them, while the longer ones appear to have almost no wear. In addition, these were not installed in any particular pattern. A set of the shorter ones were on the top reed, a longer set on the second, shorter on the third and fourth, and then longer ones on the fifth and sixth. I bought this boat from a friend, and knew the motor had a new power head installed a few years ago. I'm assuming this is when these other blocks were installed??? Is this anything I need to worry about, or just reassemble as I found it? Attached are some photos showing the difference. Thanks.
Reed Block #4.jpgReed Block #2.jpgReed Block #3.jpgReed Block #1.jpg