Does anyone have the trailer bunk lengths handy for a 2012 Z8 Trailer? Mine are rotten and time to make some new ones. I've had some leg surgery, so crawling under the boat is a bit of a challenge and I'd like to do this without unloading and reloading on bad bunks. Several got the duct tape treatment at the ramp yesterday.
Don't know if there was a change between the 2012 and 2014 but here's measurements for the 2014.
2 x 10 (2ea)
2 x 4 (2ea)
2 x 4.5 (2ea)
Wes
Helix 10 MSI+,MDI+,Ultrex IPilot
2023 Phoenix 818
Never assume there's a tomorrow
And taper the parts the reverse chines sit on
Bryan McDonough
2023 Nitro Z21 XL
Nitro Team
I appreciate it!Originally Posted by ezfishn
BMCD, can you explain what you mean by the reverse chines? I am getting ready to replace the bunks on my 2011 Z9 and was planning on having them cut and carpeted when I got to the lake so it would be an easy swapout. I assume you mean the top of the 2x4 needs to be cut to a taper?
Factory told me to route the end of the boards 12" from end and 3/8" deep. Install a couple extra layers of carpet in the eased area.
Reply With Quote