-
2005 ZX225 W/ 2005 Yamaha HDPI Setup
I just purchased a new to me Skeeter, and am needing some set up help. The Yamaha manual says 5500 RPM @ WOT for that year. My specs are below.
Prop to Pad: 3-1/4”
Prop: 25” T1
RPM: 6000-6100
Speed: 60.9 mph gps
Jack Plate: 12” Slidemaster w/a wedge between it and the motor
Load: light tournament load
I have a feeling I need to up the prop to a 27 T1/T2 and then reset the jack plate, but I have never had to mess with a jack plate before, and wanted some input from others that have done this before.
-
sounds like your prop may need to be reworked. you should be turning 5800-5900 rpms and by yourself should be running around 69-71 mph. I run a 25 T1 on my 225 HPDI and with a fishing partner tournament load around 64-65.
Try lowering your PTP also.
-
Wouldn't I want to get the RPM's to the 5400-5500 per the manual?
-
Speed at 60.9 and 6000 rpms you are blowing a lot of water it sounds like. Make sure your prop doesn’t have slip and like I said
you may need to get your prop worked. Your rpms may come down once prop is in good shape
-
What setting is your jack plate on and what bolt hole on your motor are you on?
-
i have your exact setup and with my ptp at 1-3/4 to 2" i get 64mph at 5800 rpms. that motor is a 6000 rpm motor, so not sure why it tells you that. First i've ever heard that.
I put a 26 pitch on it and the holeshot was horrible and got 63mph at 5300.
I do have a extra battery for the 36v TM system and 1 power pole for added weight.
Sounds like you need to raise your motor. Just raise it a half inch each time you go and see what happens.
Cup to the prop will help too.