I read on here a couple months ago that theres a way to deploy the both power poles with a single tap on the foot switches and dash switch. Can someone give me the procedure for this?
Thanks
I read on here a couple months ago that theres a way to deploy the both power poles with a single tap on the foot switches and dash switch. Can someone give me the procedure for this?
Thanks
On the 2.0 poles you can its done thru the c monster app.
You have to log into the C-Monster app, do a firmware update to the boards then engage the pump with the foot switch to perform the update to the switches. Once you do that you can go to remote control max settings in the app and at the very bottom is should say "special operation" turn that on and your good to go.
Thank you sir!
verywelcome that is a nice new option.
Can this be done with the 1.0? I have the app and they are synced to the app
no only the 2.0 sorry!
Can that be set for one tap for down .. and leave the up setting at two taps????
That would be handy as when I'm slowly fishing around junk and put my pole down. When I need to move with the TM, I just raise the pole up just enough to free my boat up. I wouldn't want or need the pole to fully retract every time.
mxmike - Auto operation still works as normal with single-tap auto enabled. Just a timing thing that once the button is held longer than the single tap duration it will ignore and run as manual. I hope that makes sense.