360 on helix12

[Bigtiny]

I have Solix 15 at dash . Helix 12 at trolling motor Ethernet together. I added a 360 and installed it at Ethernet port but it will show good at Solix but at helix it will lose signal after 5 mins. On the phone with huminbird and they tell me that u can’t share images through the Ethernet.they advised me to unplug the helix from Ethernet and run 360 straight to helix. After doing that it runs fine on helix. However now the helix is disconnected from Ethernet I can’t share waypoints. Please advise?

[BeantownBee]

I had to run a ethernet cable from the 360 to my ethernet switch/hub (not to my Helix10 at the bow). I also have a ethernet cable from my Helix 10 to that same ethernet switch/hub and can share 360 images with all my units(helix,Solix and Onix). Hope that helps?

Brian

[Wayne P.]

This is a bow 360 sharing the 360 to a Helix 12 CHIRP SI GPS, a SOLIX SI, and an ONIX 10 SI.

[Wormdunker]

This is a bow 360 sharing the 360 to a Helix 12 CHIRP SI GPS, a SOLIX SI, and an ONIX 10 SI.

That is like 1080. Will be 1080P (4K) with Mega.

[Wayne P.]

That is like 1080. Will be 1080P (4K) with Mega.

The image is the display resolution.

With a MEGA unit, you have 455 kHz, 800 kHz, and 1200 kHz for SI and DI. The difference in the image quality is the size of the Imaging pulse that does the scanning. The higher the frequency, the thinner the pulse = higher detail.

[Wormdunker]

The image is the display resolution.

With a MEGA unit, you have 455 kHz, 800 kHz, and 1200 kHz for SI and DI. The difference in the image quality is the size of the Imaging pulse that does the scanning. The higher the frequency, the thinner the pulse = higher detail.

I was joking, you have 3 screens of 360. 3 x 360 = 1080....