Very clean, do you have a parts list and cost?
What exactly are you looking for?
Basically, a TH Marine Products Troll Tamer with an added TH pull cable. Put the handle on the TM cable, drilled a hole in the TT arm and used the cable and MK handle.
Only other thing is I milled the catch pin down so TM store catch wouldn't latch. So, only pull TT cable and deploy TM.
Cable cover came from Amazon, split loom that you can get in a lot of different colors.
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
Looks good !! I like it !
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
I've had one on my last 3 trolling motors. I try to tell everyone about it. Its a MUST have for big rough waters.
Mike
2019 Ranger 520L w/ 250HO ETEC G2
2011 Tracker 175TXW w/ 75HO ETEC
Wish they made one short enough for my boat. I only have 2 3/8" from bottom of stowed Ultrex and deck on my Skeeter.
Phoenix 2021 721 ProXP
250 V8 ProXS
I have seen people with the similar problem use a piece of aluminium angle iron. 1"x 1" piece bolted (not screwed) on to the side of the MK bracket (instead of the bottom) facing the foot pedal. Mount the troll tamer to the bottom of the angle iron. Clean up the edges and make the angle iron look nice and there you go.