Results 1 to 3 of 3
  1. 06-10-2019, 06:31 PM #1
    Ranger62
    Ranger62 is offline
    Member
    Join Date
    Aug 2014
    Location
    Gainesville,Georgia
    Posts
    779

    Flo torq hub removal

    Trying to remove the drive sleeve from a Trophy Plus prop and can't get it to budge. Appears to be stuck and turned sideways got a screwdriver wedged in there and no luck. Any suggestions? TIA.
    Reply With Quote Reply With Quote
  2. mdtritn21
    mdtritn21 is offline
    Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #2 06-10-2019, 07:19 PM
    If it's a flo torq hub you just drive it out with a rod, a socket or something round from the nut end. Put the prop on two pieces of board with the square end down so you don't damage it and drive it out. How did it get turned side ways?
    Reply With Quote Reply With Quote
  3. 21XDC
    21XDC is offline
    Moderator 21XDC's Avatar
    Join Date
    Sep 2004
    Location
    Westland Michigan
    Posts
    63,428
    #3 06-10-2019, 08:34 PM
    Take out the aft adapter, Turn it 45* and set on top of the delrin drive sleve and hit it with a hammer... Make sure prop is not going to be in contact with anything that can damage it.

    Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »