I have a question....I have a customer that I’m totally redoing his boat front to back. He’s buy new buckets and box for the middle. Is there any hardware needed to make the change? He’s dropping everything off in a couple weeks. Thanks.
I have a question....I have a customer that I’m totally redoing his boat front to back. He’s buy new buckets and box for the middle. Is there any hardware needed to make the change? He’s dropping everything off in a couple weeks. Thanks.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
Shouldn't really take much. You may want some new screws.
Butch Derickson
2011 Z521 w/250 hp SHO
Traverse City, Michigan
I guess my question is additional hardware needed from the original bench seat. I’m sure I can figure it out. I just thought some of you had made the change.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
I remember a thread that was on here ('Ranger page part of BBC') where a guy swapped his seat setup (the '2 seats w/jump seat') to the 'dual buckets w/coin box' and he talked about how he did it. I would share the link, but I'm the worlds worst at finding what I'm looking for on a Search. I swear it was in the last year and it was either a Z20/Z21 or a Z520/Z521.
Hope it helped.
-391v
'09 Ranger Z520 Silverado Edition / '09 Evinrude ETEC 250 HO
'15 Xpress HD16DBX / Merc 59ci
This was what I did. Bench seat to buckets and coin box
http://www.bbcboards.net/showthread....382&highlight=
Then added this coin box from BassBoatSeats.com
Last edited by wmitch2; 06-12-2019 at 04:11 PM.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
Reply With Quote