Results 1 to 5 of 5
  1. 06-01-2019, 07:56 PM #1
    ameneddie
    ameneddie is offline
    Member
    Join Date
    Apr 2012
    Location
    b'ham al
    Posts
    1,208

    Shoot thru hull transducer in 2005 200 Pro XL

    Will it work & where in back of boat is best place to glue it in. Thanks
    Reply With Quote Reply With Quote
  2. 201pro
    201pro is offline
    Member
    Join Date
    Nov 2004
    Location
    Columbus, Indiana
    Posts
    4,235
    #2 06-01-2019, 09:03 PM
    Yes it will work. It should already have one in the correct area. Any flat space in the area just in front of the drain hole will work.
    Reply With Quote Reply With Quote
  3. Javelin389
    Javelin389 is offline
    Forensicator Javelin389's Avatar
    Join Date
    Jul 2004
    Location
    Lebanon, TN
    Posts
    12,755
    #3 06-02-2019, 05:45 AM
    ^^This^^
    Reply With Quote Reply With Quote
  4. javelin90
    javelin90 is offline
    Member
    Join Date
    May 2007
    Location
    Colonial Heights Virginia
    Posts
    5,122
    #4 06-02-2019, 08:42 AM
    If you have to install a transducer for the unit that you are using make sure to use the two part epoxy and a paver or brick placed on top of transducer to ensure no air bubbles. For example Humminbird has a two part epoxy.
    Reply With Quote Reply With Quote
  5. Jumping Jimmy
    Jumping Jimmy is offline
    Member
    Join Date
    Jul 2005
    Location
    Norfolk Virginia
    Posts
    3,325
    #5 06-02-2019, 08:51 AM
    There is a flat spot made into the bottom for the transducer. On mine it is located just right of center looking from the back of the boat. You will know when you see it.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »