No power to gauges or trim switches

[TrackerPT175TXW]

So i installed livescope and a 10” Echomap Ultra today and decided to rewire other electronics to a busbar so i can turn them all on/off with Livescope. All of the new and old electronics are working, deck lights, livewell, bilge etc. but i have no gauges, ignition or any of the trim switches. I took alot of the panels off , seats etc to run new wiring. I started to take off panel holding throttle and realized that probably wasnt a good idea or necessary. Anyone have any suggestions??? Went from super stoked to super bummed pretty quick. Any advice would be appreciated

I guess i should mention that its a 2015 175txw with 60hp fourstroke

[jprovencher80]

Call Tracker customer relations and ask for the wiring diagram for your boat to be emailed to you. After you have it, use a multimeter to verify 12v at the connections. You'll find the issue

[TrackerPT175TXW]

Thanks. I think I have it narrowed done to a small area at least. Had to leave it alone for awhile

[TrackerPT175TXW]

Still nothing. Open to suggestions

[gatorglenn]

Go under the cowling on motor. There is fuses there that you must of ground and blew. To start, look for a 20 in a yellow plug. On front of motor, on top of air in take.

[TrackerPT175TXW]

Thanks for the suggestions. Got it going.

[High Tide]

Did you rewire with the battery disconnected? Blown fuse(s) is a good start.

[TrackerPT175TXW]

Got it going. Someone forgot to connect motor harness to battery

[rayburnrat]

Got it going. Someone forgot to connect motor harness to battery

Heh Heh. Who?

[TrackerPT175TXW]

Meh i don’t know ����*♂️

[jprovencher80]

Damned hired help....