Has any one changed out the prop shaft seals on a Fortrex 80 24volt. Trying to figger out how to get them out. Any help would be appreciated.
Has any one changed out the prop shaft seals on a Fortrex 80 24volt. Trying to figger out how to get them out. Any help would be appreciated.
After removal of the com cap and brush card, you will go through the "seal" end with a punch and remove the bushing, (be careful not to damage the bushing - can also use a sacrificial socket) then turn the com cap over and using a punch remove the outer seal then the inner seal.
John
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
Thanks John. After posting I did find and older thread where you had mentioned this procedure. Any advise on the removal and installation of the armature bearing.
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
You are the man John!!! Seals are out and bearing will be off shortly. Big thanks for all you do!!!!!