so most of the Alums have the track systems in them now - VersaTrack on the tracker - AccesaTrack on the Polar Kraft etc etc etc...is there some good source where to buy the actual accessories for the track systems?
so most of the Alums have the track systems in them now - VersaTrack on the tracker - AccesaTrack on the Polar Kraft etc etc etc...is there some good source where to buy the actual accessories for the track systems?
used Berts accesories for mounting graph near console.
mount.jpg
mount 1.jpg
mount 2.jpg
thank you sir - will look about
Or you can make your own out of starboard . The bolts and wing nuts can be had at BPS for about 7 bucks a pair. You can also use what’s called a closest bolt made for installing toilets to their flanges. If you use them make sure you get brass . The hardware store has potmetal ones too. Also you will need stainless 3/8 wing nuts.
I use 1/4" stainless steel carriage bolts and stainless wingnuts on all of my homemade fixtures. 1/4" thick x 2.5" or 3" aluminum angle makes great mounting platforms for all sorts of useful stuff. I have my driftmaster rod holders mounted this way.
Joe B
2017 Tracker PT 190 TX
2017 Mercury 115 Pro XS
Mercury Spitfire X7 19” prop
51 mph @ 6240 rpms (RPMs from Vessel View Mobile) : full fuel tank and fishing load by myself
4.2 second Hole Shot (measured using Vessel View Mobile)
Engine mounted in 3rd hole
Minn Kota Ulterra-Link w/built in MDI 80 lb thrust 60” shaft
Humminbird Helix 12si Gen1 chirp on console
Humminbird Helix 15si Gen4 cho on bow
Humminbird Mega360
Dotline two step transom boarding ladder
Tracker trailer bow boarding step
Lund sells a lot of stuff. Cisco does as well.
Heads up on what you get:
Different boats use a different "angle degree" on their accessory tracks. Make sure you get the correct stuff.
Reply With Quote