-
2019 FX 20 Factory Cover
I just received my new factory boat cover, I know they are not difficult but they come with no installation details. Can anyone provide any of this information ?
-
Start at the bow and cover the nose. Cover fits best when the trolling motor is mounted lowest to head.
Pull cover to the back. Release and open the ratchet straps in the pockets. Set up 2 props if desired
Pull rear of cover over the sponsons. Make sure cover is pulled around the sides
Run rear strap hooks to Jackplate.
Run the 4 front straps down to trailer. Loop back up put one twist and clip in. Twist keeps the straps from flapping loose. Make sure these are tight.
Tighten one ratchet side enough... 2-3 rotations, now do the other and the cover will suck together like shrink wrap.
Attach the rear of the cover together by the motor.
skeeter14.jpgskeeter15.jpgskeeter16.jpg
Roger Xiong Jr
Mukwonago, WI
rxiong21@gmail.com
2018 Skeeter ZX250 250 Yamaha SHO
-
Thank you very much
Just what I was looking for.