Just purchased a atlas hydraulic jack plate for my 2017 Z21 and getting ready to install.
My question is ...witch upper mount holes on your jack plate are you using.
There are two upper mount holes on each side of the jack plate to choose from to mount to the boat.
Is your top bolts through the upper holes or the lower holes ?
Please let me know , thank you
2017 NITRO Z21
250 MERCURY PRO XS
POWER POLE BLADES
LOWRANCE ELECTRONICS
PRECISION SONAR MOUNTS
you want the motor to be centered in the sweet spot for your hull, maximum down and up from running in perfect conditions, just figure it out as no one has stopped by with how theirs is set up
Mercury 250 proxs 2B115089
I have the same boat and jack plate. My dealer installed mine. I had to have them raise it as it was too low. I don't remember what holes it was in but can take some pictures of it this weekend.
'17 Nitro Z21, 250ProXS serial # 2B399616, 24p Fury4, 12" Atlas, Apex 16 @ console, Apex 16 & Apex 13 @ bow, Mega 360, Ultrex, 8ft blades
I want to say I had it on the top hole on my 2017.
Bryan McDonough
2023 Nitro Z21 XL
Nitro Team
Reply With Quote