1E003823
Noticed my tank on engine was down about 1/4 inch or less after last out. Whats up?
1E003823
Noticed my tank on engine was down about 1/4 inch or less after last out. Whats up?
Ron Fears
Stroker/300XS
1E003823
loose cap, or air leak, on remote tank/hoses.
Check valve going bad.
Just watch and I know hoses are good, just installed new clamps etc. Will check all caps and anything else i can see. Going to ride around a bit this weekend, will see if anything changes, from what i said u think i should?
Ron Fears
Stroker/300XS
1E003823
I used omc clamps by the way like them a bunch
Ron Fears
Stroker/300XS
1E003823
Seal inside the cap?
You will also see this occasionally if you let the remote tank get low and run some rough water. Other than that check everything Savage said on the remote tank.
From the FAQ Section:
Bleeding air from the Engine Mounted Oil Tank
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Just rebuilt my 300XS after a check valve failure. #6 cylinder had 0 PSI. The rest had 125. You can bet it will become part of my maintenance. Probably every other year. Cheap insurance.
Ok where is check valve
Ron Fears
Stroker/300XS
1E003823
The one on the block that supplies air to remote tank in boat. Starboard side on block beneath starter.
Cool thanks, just replace
Ron Fears
Stroker/300XS
1E003823