OK the history
I bought a 2010 FX 21 with 48 hours on the clock, the TSB had never been done on the engine, before buying and knowing this engine was in the TSB range I had a Yamaha mechanic contact corporate and see if they would cover the block, they did and it was replaced in Janurary, all is well.
I ran the engine the first two hours per mechanics instructions and dropped the oil and filter and put in fresh, I know, probably not necessary but it's done. I put in 6 1/2 quarts and it was half way between the marks on the stick, leaving room in case it made oil which these engines are famous for. Well it has, at almost 8 hours the level is at the full mark, so about a half quart of diluted fuel is mixed with the oil.
Advise:
do I just drain it down a little and proceed or start over fresh? run it like it is? I don't like the idea of diluted oil in a new engine.
the last few hours have been just normal running while fishing.
Take it out and run the crap out of it?
need advise from those who have been there.