i am ready to try again to try and program my dash switch to my duel poles, the first time i tried i was unsuccessful, any helpful hints. if it dont work this time i will just keep using my fob
i am ready to try again to try and program my dash switch to my duel poles, the first time i tried i was unsuccessful, any helpful hints. if it dont work this time i will just keep using my fob
Make sure the switch is set set so it is in duel pole mode. Press and hold both program buttons down on pump at same time till hear audiable beep push the down button on switch, repeat procedure for the up. should be all set. From there you can change the setting to just work the port or just the starboard or both. Important that the advanced switch is set on the setting to work both poles when programming ( both led lights lit up)
I wasn't able to program mine till I used the mobile app
Mercury 250 proxs 2B115089
Mercury 250 proxs 2B115089
Did you gave the switch set so both lights were lit up , meaning set to control both port and starboard
thanks Kevin i will give it a try and see what happens