They were rigged by the dealer, each unit only lists itself when you go to the Network settings.... Ethernet is connected. Where should I start?
Software for both has been updated to 1.9
They were rigged by the dealer, each unit only lists itself when you go to the Network settings.... Ethernet is connected. Where should I start?
Software for both has been updated to 1.9
Layton Strong
Nitro State Team
If Ethernet is connected, you wait until Ethernet is recognized by each unit.
I was using the Ethernet Switch yesterday and it took a few minutes before the DI unit got the SI tab.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
So far in my testing I cannot verify what the issue is? It is a simple cable with two simple dongles, so as long as the connections are tight between the three pieces, and they are plugged into each unit, it should work?
I don't have access to extra dongles without buying new, I do believe I found an extra ethernet cable in my stash of HB extra parts from years ago just the other day, but have not had the time to verify it is correct.
Being intermittent I don't know if OHM testing will be of any help???
Besides that both units are preforming great.............. 9 DI g2n & 10 SI g2n
Do both units show an IP address?
Could be where the cables are run causing interference. Could be a short in one of the cables.
I found the problem! The Dongle was not connected under the bow plate...
This may be my fault as I may have disconnected it to clean up and arrange the cables when I hooked up my Hydrowave.
Sorry for wasting your time!!!
Layton Strong
Nitro State Team
Neat has never served me well!