should the two control boxes be mounted away from the fuel tank? In the back of the ChampioN the center compartment is fuel tank and the outer compartments are batteries and charger with a divider wall between them. I was going to mount the boxes to this wall. would be easier to mount in the fuel tank side but have a concern for flammable vapors? Not sure if those boxes are intrinsically safe.
Depending on where I mount them I may need to extend the wires. I will make sure the diameter is correct but does it have to be a marine type wire?
Also I bought this Pro Series pole used. a single pole. It has small diameter black and blue lines that I can screw back in place if I go through the cable boot. Or do I need to buy the fittings to go through the glass?? Should I replace the lines even though they show no issues?
I built the pump mount myself to mount to the inside threads for the motor mount bolts. Had a board member here print me up a new switch panel with a 3-D printer for beside the drivers seat to handle the switch. Just still trying to piece all this together before attempting an install.
Thanks.