How do I adjust the trim gauge on 2019 Pro XS 250 4 stroke

[ARL37]

I have a new Pro XS 250 4 on my new Ranger Z521L. The trim gauge is way off. The motor trims and trims up before the needle on the gauge ever moves. How do I adjust the trim to be accurately reflected on the gauge? The sensor on the Pro XS 250 4 is NOT like the old sensors that you could just loosen two bolts and then rotate to adjust the trim setting. The sensor on this motor has no slots to allow you to rotate. The the trim gauge is at the bottom of the speedometer. The build sheet says "Gauges. Z-Elite,Pro XS (4s),Dig."

How do I adjust the trim to accurately be reflected on the gauge?

[SilverFox579]

Try posting in the 4-stroke forum 3 below this one and be sure to include your engine serial number, especially important with the new 4-strokes as there are numerous models. Were it mine, I'd take it back to the dealer to correct, as that should have been part of the pre-delivery inspection.

[ARL37]

Thanks. This my first post. Sorry i didn't post it correctly