Ultrex Momentary switch stopped working

[cobra-drvr]

When I first installed the Ultrex I had adjust the reed switch to prevent the momentary switch from remaining on when not depressed. Yesterday after about 6 hours of use it just stopped working at all, it does nothing when it is depressed. Motor itself is fine as it works when the "constant" button is used.

Do I need to adjust the reed switch again? If so does anyone have the post that shows/describes how to do that? I searched for it but cant find it.

thanks
bp

[fishnfireman]

Some have a very small (just right spot)
Turn the motor until front of pedal is full up--so you can see the bottom of reed switch --should be able to push it back up.
You can also see the removal tab for the button from underside.. If you just need to raise the switch you can do that with out removing the button.

[cobra-drvr]

quick followup, had to adjust it again to get it working. Strange.