Hey yall.
Having a couple issues with my 05 250 verado trimming correctly. The first issue it had was the smartcraft gauge and the trim gauge on my dash would bounce up and down while the motor stayed trimmed in the same spot. This caused my boat to limit the motor to only 2k RPMs. Had a shop diagnose this as a bad trim sensor. Replaced the sensor and now I dont have the trim bouncing up and down or rev limit, but now my boat wont trim up near as far as it should and almost seems like it doesnt trim down as far as it should either. Lost about 20 MPH.
Any suggestions on whats going on here? Do my trim limits just need to be reset? Does the computer not do that automatically?
Any help is greatly appreciated!