Results 1 to 4 of 4
  1. 03-22-2019, 10:23 PM #1
    UNAbass49
    UNAbass49 is offline
    Member
    Join Date
    Apr 2012
    Location
    Muskegon, MI
    Posts
    90

    Powerpole blade issue

    When I went out to the garage today I could here the pump on one pole kicking on and off for short cycles then just be stuck on a solid green light on the pump. I checked all wiring and fuses, and also disconnected the top cap and the issue was still happening. Does it need a new board and too cap?
    Reply With Quote Reply With Quote
  2. KandKKustomz
    KandKKustomz is offline
    BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,937
    #2 03-23-2019, 07:27 AM
    Did you remove the positive lead from that pump , and then reconnect to battery? (Power cycle).


    Reply With Quote Reply With Quote
  3. UNAbass49
    UNAbass49 is offline
    Member
    Join Date
    Apr 2012
    Location
    Muskegon, MI
    Posts
    90
    #3 03-23-2019, 08:44 AM
    Yes put a whole new inline fuse
    Reply With Quote Reply With Quote
  4. KandKKustomz
    KandKKustomz is offline
    BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,937
    #4 03-23-2019, 09:25 AM
    Call Power Pole have them run a diagnostic thru the app.. im guessing need a board, no top cap. But they will confirm.


    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »