-
Ultrex universal sonar wire damaged
The wire for the universal sonar that comes out of the head of my Ultrex 112 was damaged when the head did a 360,
apparently I did not leave enough slack in the wire. It ripped apart and the threads on the metal male part were ripped in half. The sonar still works but the temperature doesn’t. I tried to look this part up to replace it but I am not having any luck. Really don’t want to bring it to a service center. Anybody else have this issue or does anyone know where I can get this wire that I need to replace. Thanks in advance. eagle521
-
Parts manual for Ultrex : https://www.minnkotamotors.com/sites...-2297160rb.pdf
I believe it is 142 for part ID , Part # 2211415, CABLE-EXTENSION, PD/AP 110"
-
Thanks for your reply, however I believe #142 is the long wire. My issue is with the wire that connects with tha one. eagle521
-
That says it is 110 inches. Just over 9'. But you have the parts document now.
This is the Ultrex manual. Page 8 has a drawing. https://minnkotamotors.johnsonoutdoo...hoCyWEQAvD_BwE
Last edited by bobcoy; 03-17-2019 at 01:28 PM.
-
Thanks again, you are correct. I thought that piece connected at the head of the unit. I took the cover off and I see that it goes through the shaft to the motor. I have know idea how I would replace that wire. eagle521
-
Take it to a Minn Kota repair center
Not sure how far it is but the closest one
NJ TROLLING MOTORS - (ASC)
108 DON CONNOR BLVD
JACKSON,
NJ
08527
732-833-1610
M-F: 9-5
Last edited by bobcoy; 03-18-2019 at 12:39 PM.