Anyone have this model and went to talons that can share some pics or things they learned in installation? I have a hyrdraulic jack plate that says ranger along the side. Wondering what elbow bracket I’d need and do I have drill into the jackplate ?
Anyone have this model and went to talons that can share some pics or things they learned in installation? I have a hyrdraulic jack plate that says ranger along the side. Wondering what elbow bracket I’d need and do I have drill into the jackplate ?
Sounds like an older bobs. It probably doesn’t have holes for mounting the brackets. I think bobs has a template so you can drill the holes. No clue on bracket
Mine are in between the transom and jackplate, they where on boat when I purchased it, one power pole bracket on starboard side and a shim on the other. It actually sets jackplate back about 1/2 of an inch. If it was easy to remove it, I would, no need for power poles where I fish. Same Bob's Ranger jackplate as you. 03 521vx.
Last edited by Lanierspook; 03-04-2019 at 10:23 PM. Reason: Clarity
Anyone else have thoughts. It’s an Older Atlas hydraulic jackpate
Should I contact minn Kota? Here’s a pic
Am i looking at the side of the jack plate? You need 2 bolts on the side of the plate to mount the talons to.
I am getting ready to mount mine this weekend so i just looked at it to make sure i had the right set up after reading this.
2004 Ranger 521VX with 2019 Evinrude G2 250 H.O.
Dartman has them on his 03 521VX.
Joe Galada - Tamaqua, PA
2004 Ranger 521VX - Yamaha 250 SHO
you will need a spacer for it to work.. i drilled mine and never had a problem. going on 4 years now..
Vince Dart- Jim Thorpe PA
i will ad my boat is happier with 8' footers had 12' ones at first.
Vince Dart- Jim Thorpe PA